Tools needed:
– Small flat head screwdriver
– Wire cutters / strippers
– Small pliers
________________________________________________________________________________________________________________
Start by taking the small screw and putting a washer around it. Then push the screw through one end of the foam.
________________________________________________________________________________________________________________
Cut a piece of wire about 5″ long and strip about 1/2″ off of one end. Loop the exposed wire around the screw.
________________________________________________________________________________________________________________
Screw the other washer and one of the nuts over the wire and tighten it up.
________________________________________________________________________________________________________________
The stylus is very simple. Screw the remaining two nuts on the end of the long screw as show. Strip off an end of the remaining wire and loop wrap it between the nuts. Tighten them together and you’re done.
________________________________________________________________________________________________________________
Now strip off the other ends of the wires and insert them into the PAL198X.
The rest is up to you.
Good luck from the Static Tongues Amplidrome.