Resistors and LEDs
An small board is used to hold the RGB LEDs.
Install the six resistors just as before. Use 100 Ohm resistors (brown black brown) in the spaces marked 82.
The LEDs go in as shown. The longest lead goes into the square pad.
Attach four leads clipped from the resistors to the four pads on the edge of the board. These will connect to the main Thingamagoop 2 PCB.
Mount the two boards together, leaving about 1/4″ of space between them. The lead with square pad will go into the square pad on the the main PCB.
Come back to this addendum once it’s time to put on the face plate
Back to Thingamagoop 2 instructions.
The front plate mounts just like the ones in the standard Thingamagoop 2 but care must be taken not to damage it.
Do not over tighten the black plastic screws or component nuts.
If your face plate gets dirty, use a microfiber cloth and water to clean it. Household cleaners will leave marks or make the plate hazy.